TSTool / Command / EndFor

• Overview
• Command Editor
• Command Syntax
• Examples
• Troubleshooting
• See Also

---

Overview

The EndFor command ends a block of commands that start with a For command. The For and EndFor commands must have the same value for the Name parameter to allow the processor to determine the start and end of the block.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

EndFor Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

EndFor(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
Name required	The name that will be matched with the name of an For command to indicate the block of commands in the loop.	None - must be specified.

Examples

See the automated tests.

Troubleshooting

See Also

• For command