Skip to content

StateDMI / Command / FillCULocation

Overview

The FillCULocation command (for StateMod) fills missing data in existing CU Locations.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillCULocation

FillCULocation Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillCULocation(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single CU Location identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Name The name to be assigned for matching locations. If not specified, the original value will remain.
Latitude The latitude to be assigned for all matching CU Locations with missing latitude. If not specified, the original value will remain.
Elevation The elevation to be assigned for matching locations. If not specified, the original value will remain.
Region1 The Region1 to be assigned for all matching CU Locations with missing Region1. If not specified, the original value will remain.
Region2 The Region2 to be assigned for all matching CU Locations with missing Region2. If not specified, the original value will remain.
AWC The available water content (AWC) to be assigned for all matching CU Locations with missing AWC. If not specified, the original value will remain.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID pattern is not matched
  • Ignore – ignore (don’t generate a message) if the ID pattern is not matched
  • Warn – generate a warning message if the ID pattern is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See Also