StateDMI / Command / SetInstreamFlowStation

Overview

The SetInstreamFlowStation command (for StateMod) sets data in existing instream flow stations or adds a new instream flow station.

The following dialog is used to edit the command and illustrates the command syntax.

SetInstreamFlowStation Command Editor (see also the full-size image)

The command syntax is as follows:

SetInstreamFlowStation(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID` required	A single instream flow station identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`Name`	The name to be assigned for all matching instream flow stations.	If not specified, the original value will remain.
`UpstreamRiverNodeID`	The upstream river node identifier to be assigned for all matching instream flow stations.	If not specified, the original value will remain.
`DownstreamRiverNodeID`	The downstream river node identifier to be assigned for all matching instream flow stations.	If not specified, the original value will remain.
`OnOff`	The on/off switch value to be assigned for all matching instream flow stations, either 1 for on or 0 for off.	If not specified, the original value will remain.
`DailyID`	The daily identifier to be assigned for all matching instream flow stations.	If not specified, the original value will remain.
`DemandType`	The demand type to be assigned for all matching instream flow stations, one of: `1` – Average monthly demand, `2` – Monthly demand.`	If not specified, the original value will remain.
`IfNotFound`	Used for error handling, one of the following: Add – add the instream flow station if the ID is not matched and is not a wildcard Fail – generate a failure message if the ID is not matched Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched Warn – generate a warning message if the ID is not matched	Warn