Skip to content

StateDMI / Command / SetWellHistoricalPumpingTSMonthlyConstant

Overview

The SetWellHistoricalPumpingTSMonthlyConstant command (for StateCU and StateMod) sets well historical pumping time series (monthly) data to a constant value. The output period can be set or will default to that defined by the most recent SetOutputPeriod command.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetWellHistoricalPumpingTSMonthlyConstant

SetWellHistoricalPumpingTSMonthlyConstant Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetWellHistoricalPumpingTSMonthlyConstant(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID
required		 A single well station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Constant A constant historical value to set. None – must be specified.
SetStart The start of the period for the set, in a standard date/time format for monthly data (e.g., YYYY-MM or MM/YYYY). The output period start.
SetEnd The end of the period for the set, in a standard date/time format for monthly data (e.g., YYYY-MM or MM/YYYY). The output period end.
RecalcLimits If True, then the time series limits will be recalculated as if the provided values are observations. If False, the limits from before the set will remain. True
IfNotFound Used for error handling, one of the following:
  • Add – add the time series if the ID is not matched and is not a wildcard
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See Also