StateDMI / Command / FillWellRight

Overview

The FillWellRight command (for StateMod) fills missing data in existing well rights.

The following dialog is used to edit the command and illustrates the command syntax.

FillWellRight Command Editor (see also the full-size image)

The command syntax is as follows:

FillWellRight(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID`	A single well right identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`Name`	The name to be assigned for all matching well right identifiers with missing name.	If not specified, the original value will remain.
`StationID`	The well station identifier to be assigned for all matching well right identifiers with missing well station identifier.	If not specified, the original value will remain.
`AdministrationNumber`	The administration number to be assigned for all matching well right identifiers with missing administration number.	If not specified, the original value will remain.
`Decree`	The water right decree to be assigned for all matching well right identifiers with missing administration decree.	If not specified, the original value will remain.
`OnOff`	The on/off switch to be assigned for all matching well right identifiers with missing on/off switch, either 1 for on or 0 for off, a positive 4-digit year to turn the right on starting in the year, or a negative 4-digit year to turn the right off starting in the year.	If not specified, the original value will remain.
`IfNotFound`	Used for error handling, one of the following: `Fail` – generate a failure message if the ID is not matched `Ignore` – ignore (don’t generate a message) if the ID is not matched `Warn` – generate a warning message if the ID is not matched	`Warn`