Skip to content

StateDMI / Command / FillWellStationsFromDiversionStations

Overview

The FillWellStationsFromDiversionStations command (for StateMod) fills missing well station data for each location, using the corresponding diversion station (only for D&W model nodes). The diversion stations must have been read or assigned with previous commands. The following data are filled: name, demand source, demand type, use type.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillWellStationsFromDiversionStations

FillWellStationsFromDiversionStations Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillWellStationsFromDiversionStations(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single well station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See Also