StateDMI / Command / SetDebugLevel

• Overview
• Command Editor
• Command Syntax
• Examples
• Troubleshooting
• See Also

---

Overview

The SetDebugLevel command is used to set debug levels for the screen and log file.

Debug messages are useful during troubleshooting. A general guideline is that a debug level of 1 prints basic messages, 30 prints detailed information about processing, and 100 prints very low-level messages about input/output. Intermediate values will result in more or less output.

This command is useful for troubleshooting and can be specified multiple times to increase debug output for a specific command, if necessary.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetDebugLevel Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetDebugLevel(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
ScreenLevel	Level for screen (user interface) messages.	Only important messages will be shown.
LogFileLevel	Level for log file messages.	Only important messages will be printed to the log file.

Examples

See the automated tests.

Troubleshooting

See Also

• SetWarningLevel command