StateDMI / Command / CheckClimateStations

• Overview
• Command Editor
• Command Syntax
• Examples
• Troubleshooting
• See Also

---

Overview

The CheckClimateStations command (for StateCU) checks the climate stations for problems. The command should usually be used with a WriteCheckFile command at the end of a command file.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

CheckClimateStations Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

CheckClimateStations(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
ID	The identifier for the station(s) to check. Use * to match a pattern.	None – must be specified.
IfNotFound	One of the following: Fail – generate a failure message if the climate station ID is not matched Ignore – ignore (don’t generate a message) if the climate station ID is not matched Warn – generate a warning message if the climate station ID is not matched	Warn

Examples

See the automated tests.

The following example command file illustrates how climate stations can be defined, sorted, checked, and written to a StateCU file:

ReadClimateStationsFromList(ListFile="climsta.lst",IDCol=1)
FillClimateStationsFromHydroBase(ID="*")
SetClimateStation(ID="3016",Region2="14080106",IfNotFound=Warn)
SetClimateStation(ID="1018",Region2="14040106",IfNotFound=Warn)
SetClimateStation(ID="1928",Elevation=6440,IfNotFound=Warn)
SetClimateStation(ID="0484",Region1="MOFFAT",IfNotFound=Add)
SortClimateStations()
WriteClimateStationsToStateCU(OutputFile="COclim2006.cli")
#
# Check the results
#
CheckClimateStations(ID="*")
WriteCheckFile(OutputFile="COclim2006.cli.check.html")

Troubleshooting

See Also

WriteCheckFile command