Skip to content

StateDMI / Command / SetInstreamFlowDemandTSAverageMonthlyFromRights

Overview

The SetInstreamFlowDemandTSAverageMonthlyFromRights command (for StateMod) sets instream flow demand time series (average monthly) data using instream flow water rights data that have been previously read (e.g., from a ReadInstreamFlowRightsFromStateMod command). The resulting time series at each instream flow station represents the total water rights for the specified station. The output year type is set to that defined by the most recent SetOutputYearType command. For average time series, it is only important that a sequence of months be specified in the time series. If water year is used, then the data span two calendar years in memory. Incorrectly specifying the year type may result in missing data in the output.

If necessary, the constant values determined from water rights can be reset using the SetInstreamFlowDemandTSAverageMonthlyConstant command.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetInstreamFlowDemandTSAverageMonthlyFromRights

SetInstreamFlowDemandTSAverageMonthlyFromRights Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetInstreamFlowDemandTSAverageMonthlyFromRights(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single instream flow station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
IfNotFound Used for error handling, one of the following:
  • Add – add the instream flow demand time series if the ID is not matched and is not a wildcard
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See Also