StateDMI / Command / CheckIrrigationPracticeTS

• Overview
• Command Editor
• Command Syntax
• Examples
• Troubleshooting
• See Also

---

Overview

The CheckIrrigationPracticeTS command (for StateCU) checks the irrigation practice time series data for problems. The command should usually be used with a WriteCheckFile command at the end of a command file.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

CheckIrrigationPracticeTS Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

CheckIrrigationPracticeTS(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
ID	The location identifiers for the time series to check. Use * to match a pattern.	None – must be specified.
IfNotFound	One of the following: Fail – generate a failure message if the identifier is not matched Ignore – ignore (don’t generate a message) if the identifier is not matched Warn – generate a warning message if the identifier is not matched	Warn

Examples

See the automated tests.

The following excerpt from a command file illustrates how irrigation practice time series can be checked and written to a StateCU file:

#
#  Create irrigation practice file
#
WriteIrrigationPracticeTSToStateCU(OutputFile="cm2006.ipy")
#
# Check the results
CheckIrrigationPracticeTS(ID="*")
WriteCheckFile(OutputFile="ipy.commands.StateDMI.check.html")

Troubleshooting

See the main troubleshooting documentation

See Also

• WriteCheckFile command