Skip to content

StateDMI / Command / FillClimateStation

Overview

The FillClimateStation command (for StateCU) fills missing data in existing climate stations.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillClimateStation command editor

FillClimateStation Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillClimateStation(Parameter="Value",...)

Command Parameters

Parameter                     Description Default          
ID A single climate station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Latitude The climate station latitude to be assigned for all matching climate stations with missing latitude. If not specified, the original value will remain.
Elevation The climate station elevation to be assigned for all matching climate stations with missing elevation. If not specified, the original value will remain.
Region1 The climate station Region1 (typically county) to be assigned for all matching climate stations with missing Region1. If not specified, the original value will remain.
Region2 The climate station Region2 (traditionally HUC but can be blank) to be assigned for all matching climate stations with missing Region2. If not specified, the original value will remain.
Name The climate station name to be assigned for all matching climate stations with missing name. If not specified, the original value will remain.
HeightHumidityMeas The height of humidity and temperature measurements (feet), only used with daily analysis. If not specified, the original value will remain.
HeightWindMeas The height of wind measurements (feet), only used with daily analysis. If not specified, the original value will remain.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID pattern is not matched
  • Ignore – ignore (don’t generate a message) if the ID pattern is not matched
  • Warn – generate a warning message if the ID pattern is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also