StateDMI / Command / SetStreamEstimateStation

Overview

The SetStreamEstimateStation command (for StateMod) sets data in existing stream estimate stations or adds a new stream estimate station.

The following dialog is used to edit the command and illustrates the command syntax.

SetStreamEstimateStation Command Editor (see also the full-size image)

The command syntax is as follows:

SetStreamEstimateStation(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID` required	A single stream estimate station identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`Name`	The name to be assigned for all matching stream estimate stations.	If not specified, the original value will remain.
`RiverNodeID`	The river node identifier to be assigned for all matching stream estimate stations.	If not specified, the original value will remain.
`DailyID`	The daily identifier to be assigned for all matching stream estimate stations.	If not specified, the original value will remain.
`IfNotFound`	Used for error handling, one of the following: `Add` – add the stream estimate station if the ID is not matched and is not a wildcard `Fail` – generate a failure message if the ID is not matched `Ignore` – ignore (don’t add and don’t generate a message) if the ID is not matched `Warn` – generate a warning message if the ID is not matched	`Warn`