Skip to content

StateDMI / Command / SetWellStationAreaToCropPatternTS

Overview

The SetWellStationAreaToCropPatternTS command (for StateMod) sets the well station area for each well station to the maximum crop pattern time series total area. The crop pattern time series must have been read or assigned with previous commands. If there is no crop pattern time series, the area will not be set.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetWellStationAreaToCropPatternTS command editor

SetWellStationAreaToCropPatternTS Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetWellStationAreaToCropPatternTS(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID
required		 A single well station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also