StateDMI / Command / FillWellHistoricalPumpingTSMonthlyConstant

Overview
Command Editor
Command Syntax
Examples
Troubleshooting
See Also

Overview

The FillWellHistoricalPumpingTSMonthlyConstant command (for StateCU and StateMod) fills missing well historical pumping time series (monthly) data, using a constant value. This command is useful, for example, to set pumping values to zero if other fill commands are unable to provide data estimates for missing data.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillWellHistoricalPumpingTSMonthlyConstant Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillWellHistoricalPumpingTSMonthlyConstant(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID`	A single well station identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`FillStart`	The first year to fill, using format `YYYY-MM` or `MM/YYYY`.	If not specified, fill the full period.
`FillEnd`	The last year to fill, using format `YYYY-MM` or `MM/YYYY`.	If not specified, fill the full period.
`Constant`	The constant value to be used to fill missing data.	None – must be specified.
`FillFlag`	If specified as a single character, data flags will be enabled for the time series and each filled value will be tagged with the specified character. The flag can then be used later to label graphs, etc. The flag will be appended to existing flags if necessary.	No flag is assigned.
`IfNotFound`	Used for error handling, one of the following: `Fail` – generate a failure message if the ID is not matched `Ignore` – ignore (don’t generate a message) if the ID is not matched `Warn` – generate a warning message if the ID is not matched	`Warn`

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation