StateDMI / Command / SetRiverNetworkNode

Overview

The SetRiverNetworkNode command (for StateMod) sets data in existing river network nodes or adds a new river network node.

The following dialog is used to edit the command and illustrates the command syntax.

SetRiverNetworkNode Command Editor (see also the full-size image)

The command syntax is as follows:

SetRiverNetworkNode(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID`	A single river network node identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`Name`	The name to be assigned for all matching river network nodes.	If not specified, the original value will remain.
`DownstreamRiverNodeID`	The downstream river node identifier to be assigned for all matching river network nodes.	If not specified, the original value will remain.
`Comment`	The comment to be assigned for all matching river network nodes.	If not specified, the original value will remain.
`MaxRechargeLimit`	The maximum recharge limit, CFS, for groundwater modeling, assigned for all matching river network nodes.	If not specified, the original value will remain.
`IfNotFound`	Used for error handling, one of the following: `Add` – add the river network node if the ID is not matched and is not a wildcard (note that nodes that are upstream and downstream of the addition are NOT automatically changed) `Fail` – generate a failure message if the ID is not matched `Ignore` – ignore (don’t add and don’t generate a message) if the ID is not matched `Warn` – generate a warning message if the ID is not matched	`Warn`