Skip to content

TSTool / Command / ReadDateValue


Overview

The ReadDateValue command reads all the time series in a DateValue file. See the DateValue Input Type Appendix for information about the file format.

The following dialog is used to edit the command and illustrates the command syntax. The path to the file can be absolute or relative to the working directory. DateValue files allow each time series to have an alias in addition to the time series identifier (TSID); however, the Alias parameter can be used to assign a new alias as the file is read.

Command Editor

The following dialog is used to edit the command and illustrates the syntax of the command.

ReadDateValue

ReadDateValue Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

ReadDateValue(Parameter="Value",...)

The following older command syntax is updated to the above syntax when a command file is read:

TS Alias = ReadDateValue(Parameter=Value,...)

Command Parameters

Parameter            Description Default                           
InputFile
required
The name of the DateValue input file to read. Global property values can be used with the syntax ${PropertyName}. The file can be a zip or gz file with single compressed file. None – must be specified.
Alias The alias to assign to the time series, as a literal string or using the special formatting characters listed by the command editor. The alias is a short identifier used by other commands to locate time series for processing, as an alternative to the time series identifier (TSID). The alias in the file will be used if present.
NewUnits Units to convert data to (must be in the system/DATAUNIT configuration file under the TSTool installation folder). Use the data units from the file.
InputStart Starting date/time to read data, in precision consistent with data. Specify as a date/time string or a processor ${Property}. Read all data.
InputEnd Ending date/time to read data, in precision consistent with data. Specify as a date/time string or a processor ${Property}. Read all data.

Examples

See the automated tests.

A sample command file is as follows:

ReadDateValue(InputFile="Data\08251500.DWR.Streamflow.IRREGULAR.dv")

Troubleshooting

See Also