Skip to content

TSTool / Command / ReadWaterOneFlow


Overview

The ReadWaterOneFLow command was experimental and is not currently available in TSTool.

The ReadWaterOneFlow command reads one or more time series from WaterOneFlow web service (see the WaterOneFlow Data Store Appendix) and optionally assigns an alias to the time series. WaterML version 1.0 is supported for time series transfer; however, the WaterML response currently cannot be saved to a file (and therefore output cannot be used with the ReadWaterML command).

Command Editor

Command Syntax

The command syntax is as follows:

ReadWaterOneFlow(Parameter="Value",...)

Command Parameters

Parameter                          Description Default                           
Alias The alias to assign to the time series, as a literal string or using the special formatting characters listed by the command editor. The alias is a short identifier used by other commands to locate time series for processing, as an alternative to the time series identifier (TSID). No alias is assigned.
InputStart The start of the period to read data – specify if the period should be different from the global query period. Use the global query period.
InputEnd The end of the period to read data – specify if the period should be different from the global query period. Use the global query period.

Examples

See the automated tests.

Troubleshooting

See Also