TSTool / Command / ReadWaterOneFlow
Overview
The ReadWaterOneFLow command was experimental and is not currently available in TSTool.
The ReadWaterOneFlow command reads one or more time series from WaterOneFlow web service
(see the WaterOneFlow Data Store Appendix) and optionally assigns an alias to the time series.
WaterML version 1.0 is supported for time series transfer;
however, the WaterML response currently cannot be saved to a file
(and therefore output cannot be used with the
ReadWaterML command).
Command Editor
Need to add documentation.
Command Syntax
The command syntax is as follows:
ReadWaterOneFlow(Parameter="Value",...)
Command Parameters
| Parameter | Description | Default |
|---|---|---|
Alias |
The alias to assign to the time series, as a literal string or using the special formatting characters listed by the command editor. The alias is a short identifier used by other commands to locate time series for processing, as an alternative to the time series identifier (TSID). | No alias is assigned. |
InputStart |
The start of the period to read data – specify if the period should be different from the global query period. | Use the global query period. |
InputEnd |
The end of the period to read data – specify if the period should be different from the global query period. | Use the global query period. |
Examples
See the automated tests.
Troubleshooting
See the main TSTool Troubleshooting documentation.
See Also
ReadWaterMLcommandReadWaterML2command