TSTool / Command / Break
Overview
The Break command causes logic to jump out of the current For loop block.
It is typically enclosed in an If block.
Logic will continue with the command after the corresponding EndFor command.
Command Editor
The command is available in the following TSTool menu:
- Commands / General - Running and Properties
The following dialog is used to edit the command and illustrates the command syntax.
Break Command Editor (see full-size image)
Command Syntax
The command syntax is as follows:
Break()
Command Parameters
| Parameter | Description | Default |
|---|---|---|
| None | Currently the command does not use any parameters. |
Examples
See the automated tests.
Troubleshooting
See the main TSTool Troubleshooting documentation.