TSTool / Command / Continue
Overview
The Continue command causes logic to jump to the end of the current For loop block.
It is typically enclosed in an If block.
The loop will then increment the iteration property and the loop with either execute another iteration
or will be complete and logic will continue with the command after the corresponding
EndFor command.
Command Editor
The command is available in the following TSTool menu:
- Commands / General - Running and Properties
The following dialog is used to edit the command and illustrates the command syntax.
Continue Command Editor (see full-size image)
Command Syntax
The command syntax is as follows:
Continue()
Command Parameters
| Parameter | Description | Default |
|---|---|---|
| None | Currently the command does not use any parameters. |
Examples
See the automated tests.
Troubleshooting
See the main TSTool Troubleshooting documentation.