StateDMI / Command / StartRegressionTestResultsReport

Overview
Command Editor
Command Syntax
Examples
Troubleshooting
See Also

Overview

The StartRegressionTestResultsReport command starts a report file to be written to as regression tests are run. The CreateRegressionTestCommandFile automatically inserts this command. The CompareFiles command will write to this file if it is available.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

StartRegressionTestResultsReport Command Editor (see full-size image)

Command Syntax

The command syntax is as follows:

StartRegressionTestResultsReport(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`OutputFile` required	The name of the report file, enclosed in double quotes if the file contains spaces or other special characters. A path relative to the command file can be specified.	None – must be specified.
`TestResultsTableID`	The identifier of an output table to be created.	No table will be output.

Examples

See the automated tests.

See the RunCommands documentation for how to set up a regression test. The following command file illustrates how to start the results report:

StartRegressionTestResultsReport(OutputFile="RunRegressionTest_commands_general.StateDMI.out.txt")
...
RunCommands(InputFile="..\..\..\commands\ReadClimateStationsFromList\Test_ReadClimateStationsFromList.StateDMI")
...

Each of the above command files should produce expected time series results, without warnings. If any command file unexpectedly produces a warning, a warning will also be visible in StateDMI. The issue can then be evaluated to determine whether a software or configuration change is necessary.

Troubleshooting

See the main troubleshooting documentation