StateDMI / Command / SetWellStationDelayTablesFromNetwork

• Overview
• Command Editor
• Command Syntax
• Examples
• Troubleshooting
• See Also

---

Overview

The SetWellStationDelayTablesFromNetwork command (for StateMod) sets delay table data in existing well stations using network information. A default delay table is used to assign 100% of the returns to the downstream node in the network.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetWellStationDelayTablesFromNetwork Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetWellStationDelayTablesFromNetwork(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
ID required	A single well station identifier to match or a pattern using wildcards (e.g., 20*).	None – must be specified.
DefaultTable	The default delay table to use when assigning the delay tables.	1
IfNotFound	Used for error handling, one of the following: Fail – generate a failure message if the ID is not matched Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched Warn – generate a warning message if the ID is not matched	Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also

• SetWellStationDelayTablesFromRTN command