Skip to content

StateDMI / Command / FillCropPatternTSInterpolate

Overview

The FillCropPatternTSInterpolate command (for StateCU) fills crop pattern time series data for a CU Location, using interpolation. Data will not be extrapolated past the end-points and therefore another fill method (e.g., FillCropPatternTSRepeat) may be required after the interpolation command. Filling is currently always in a forward direction. If the data set contains groundwater, it is typical to fill groundwater-only crop pattern time series prior to the first year of HydroBase data using FillCropPatternTSUsingWellRights and use FillCropPatternTSRepeat and/or FillCropPatternTSInterpolate for all other time series and parts of the period.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillCropPatternTSInterpolate command editor

FillCropPatternTSInterpolate Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillCropPatternTSInterpolate(Parameter="Value",...)

Command Parameters

Parameter                                           Description Default                    
ID A single CU Location identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
CropType A single crop type to match or a pattern using wildcards (e.g., *). None – must be specified.
IncludeSurfaceWaterSupply Indicate whether locations with surface water supply should be processed (those other than groundwater-only locations). True
IncludeGroundwaterOnlySupply Indicate whether locations with only groundwater supply (collections where PartType=Parcel) should be processed. Typically this is specified as true unless the FillCropPatternTSUsingWellRights command has been applied for the fill period. True
FillStart The first year to fill. This should be a year with observations to allow interpolation. If not specified, fill the full period.
FillEnd The last year to fill. This should be a year with observations to allow interpolation. If not specified, fill the full period.
MaxIntervals The maximum number of intervals to fill in any gap. If not specified, fill the entire gap.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also