StateDMI / Command / FillWellStationsFromDiversionStations

Overview
Command Editor
Command Syntax
Examples
Troubleshooting
See Also

Overview

The FillWellStationsFromDiversionStations command (for StateMod) fills missing well station data for each location, using the corresponding diversion station (only for D&W model nodes). The diversion stations must have been read or assigned with previous commands. The following data are filled: name, demand source, demand type, use type.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillWellStationsFromDiversionStations Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillWellStationsFromDiversionStations(Parameter="Value",...)

Command Parameters

Parameter	Description	Default
`ID`	A single well station identifier to match or a pattern using wildcards (e.g., `20*`).	None – must be specified.
`IfNotFound`	Used for error handling, one of the following: `Fail` – generate a failure message if the ID is not matched `Ignore` – ignore (don’t add and don’t generate a message) if the ID is not matched `Warn` – generate a warning message if the ID is not matched	`Warn`

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation