Skip to content

StateDMI / Command / FillStreamEstimateStation

Overview

The FillStreamEstimateStation command (from StateMod) fills missing data in existing stream estimate stations.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillStreamEstimateStation command editor

FillStreamEstimateStation Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillStreamEstimateStation(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single stream estimate identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
RiverNodeID The river node identifier to be assigned for all matching stream estimate identifiers with missing river node identifier If not specified, the original value will remain.
DailyID The daily identifier to be assigned for all matching stream estimate identifiers with missing river node identifier If not specified, the original value will remain.
Name The name to be assigned for all matching stream estimate identifiers with missing name. If not specified, the original value will remain.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also