Skip to content

StateDMI / Command / SetWellDemandTSMonthlyConstant

Overview

The SetWellDemandTSMonthlyConstant command sets well demand time series (monthly) data to a constant value. The output period can be set or will default to that defined by the most recent SetOutputPeriod command. If a matching time series is not found, it can be added to the list of time series (at the end). The values that are set are treated the same as observations from HydroBase. To ensure that set values remain, use the SetWellDemandTSMonthlyConstant command after other commands that may modify the time series.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetWellDemandTSMonthlyConstant command editor

SetWellDemandTSMonthlyConstant Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetWellDemandTSMonthlyConstant(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID
required		 A single well station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Constant A constant well demand value. None – must be specified.
SetStart The start of the period for the set, in a standard date/time format for monthly data (e.g., YYYY-MM or MM/YYYY). The output period start.
SetEnd The end of the period for the set, in a standard date/time format for monthly data (e.g., YYYY-MM or MM/YYYY). The output period end.
RecalcLimits If True, then the constant values will be treated as observations and the historical averages will be recalculated with the values. False will result in the time series being set but the previous averages remaining. The averages are used with fill commands. True
IfNotFound Used for error handling, one of the following:
  • Add – add the time series if the ID is not matched and is not a wildcard
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also