Skip to content

StateDMI / Command / SetPlanStation

Overview

The SetPlanStation command (for StateMod) sets data in existing plan stations or adds a new plan station.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetPlanStation command editor

SetPlanStation Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetPlanStation(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID
required		 A single plan station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Name The name to be assigned for all matching plan stations. If not specified, the original value will remain.
RiverNodeID The river node identifier to be assigned for all matching plan stations. Specify ID to assign to the plan station identifier. If not specified, the original value will remain.
OnOff The on/off switch value to be assigned for all matching plan stations, either 1 for on or 0 for off. If not specified, the original value will remain.
PlanType The plan station type to be assigned for all matching plan stations (see StateMod documentation). If not specified, the original value will remain.
EffType The efficiency type to assign for all matching plan stations (see StateMod documentation). If not specified, the original value will remain.
EffMonthly The monthly efficiencies (percent, 0 – 100) to assign for all matching plan stations, specified as 12 comma-separated values, January to December. If not specified, the original values will remain.
ReturnType The return flow type to be assigned for all matching plan stations (see StateMod documentation). If not specified, the original value will remain.
FailureSwitch The failure switch to be assigned for all matching plan stations (see StateMod documentation). If not specified, the original value will remain.
InitialStorage The initial plan storage (ACFT) to be assigned for all matching plan stations. If not specified, the original value will remain.
SourceID The source identifier to be assigned for all matching plan stations. If not specified, the original value will remain.
UserName The source account to be assigned for all matching plan stations. If not specified, the original value will remain.
IfNotFound Used for error handling, one of the following:
  • Add – add the diversion station if the ID is not matched and is not a wildcard
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also

There are no additional related commands.