StateDMI / Command / TranslatePenmanMonteith
Overview
The TranslatePenmanMonteith
command (for StateCU)
command translates Pennman-Monteith data. In particular, it converts one crop type to another. Primary uses of the command are:
- A data source may use one variant of the crop type (e.g.,
ORCHARD W/O COVER
but the rest of a StateCU data set uses another type (e.g.,ORCHARD_WO_COVER
). In this case the command is used simply to change the spelling of a crop type. - The raw crop data may need to be adjusted to reflect differences in crops, for modeling purposes.
For example, the original data may identify pasture (e.g.,
GRASS_PASTURE
) but for modeling the crop type is set to a different value (e.g.,GRASS_PASTURE.ASCE
) for ASCE standardized coefficients. The following example illustrates a command of this type.
Command Editor
The following dialog is used to edit the command and illustrates the command syntax.
TranslatePenmanMonteith
Command Editor (see also the full-size image)
Command Syntax
The command syntax is as follows:
TranslatePenmanMonteith(Parameter="Value",...)
Command Parameters
Parameter | Description | Default |
---|---|---|
OldCropType |
A single crop type identifier to match. This crop type will be replaced with the value for NewCropType . |
None – must be specified. |
NewCropType |
The new crop type to use. | None – must be specified. |
Examples
See the automated tests.
The following simple example illustrates how to translate a crop type:
ReadPenmanMonteithFromHydroBase(PenmanMonteithMethod="PENMAN-MONTEITH_ALFALFA")
TranslatePenmanMonteith(OldCropType="ALFALFA",NewCropType=”ALFALFA.ASCE")
Troubleshooting
See the main troubleshooting documentation
See Also
There are no additional related commands.