Skip to content

StateDMI / Command / FillRiverNetworkNode

Overview

The FillRiverNetworkNode command (for StateMod) fills missing values in existing river network nodes.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillRiverNetworkNode command editor

FillRiverNetworkNode Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillRiverNetworkNode(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single river network node identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Name The name to be assigned for all matching river network nodes. If not specified, missing values will not be filled.
DownstreamRiverNodeID The downstream river node identifier to be assigned for all matching river network nodes. If not specified, missing values will not be filled.
MaxRechargeLimit The maximum recharge limit, CFS, for groundwater modeling, assigned for all matching river network nodes. If not specified, missing values will not be filled.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also