Skip to content

StateDMI / Command / SetDiversionStationDelayTablesFromNetwork

Overview

The SetDiversionStationDelayTablesFromNetwork command (for StateMod) sets delay table data in existing diversion stations using network information. A default delay table is used to assign 100% of the returns to the downstream node in the network. This command is often used to set a default before more specific delay table information is set with the SetDiversionStationDelayTablesFromRTN command.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

SetDiversionStationDelayTablesFromNetwork command editor

SetDiversionStationDelayTablesFromNetwork Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

SetDiversionStationDelayTablesFromNetwork(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID
required		 A single diversion station identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
DefaultTable
required		 The default delay table to use when assigning the delay tables. None – must be specified.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also