Skip to content

StateDMI / Command / FillStreamGageStation

Overview

The FillStreamGageStation command (for StateMod) fills missing data in existing stream gage stations.

Command Editor

The following dialog is used to edit the command and illustrates the command syntax.

FillStreamGageStation command editor

FillStreamGageStation Command Editor (see also the full-size image)

Command Syntax

The command syntax is as follows:

FillStreamGageStation(Parameter="Value",...)

Command Parameters

Parameter             Description Default          
ID A single stream gage identifier to match or a pattern using wildcards (e.g., 20*). None – must be specified.
Name The name to be assigned for all matching stream gage identifiers with missing name. If not specified, the original value will remain.
RiverNodeID The river node identifier to be assigned for all matching stream gage identifiers with missing river node identifier If not specified, the original value will remain.
DailyID The daily identifier to be assigned for all matching stream gage identifiers with missing river node identifier If not specified, the original value will remain.
IfNotFound Used for error handling, one of the following:
  • Fail – generate a failure message if the ID is not matched
  • Ignore – ignore (don’t add and don’t generate a message) if the ID is not matched
  • Warn – generate a warning message if the ID is not matched
 Warn

Examples

See the automated tests.

Troubleshooting

See the main troubleshooting documentation

See Also