StateDMI / Command / SetIrrigationPracticeTSFromStateCU
Overview
The SetIrrigationPracticeTSFromStateCU
command (for StateCU)
command sets irrigation practice data for existing CU Locations by reading information from a StateCU file.
New locations are not added.
Currently, this command will only set the total irrigated acreage,
using data from a crop pattern time series file.
The total acreage in the irrigation practice time series file is used by StateMod,
which does read the irrigation practice file, but not the crop pattern file.
Command Editor
The following dialog is used to edit the command and illustrates the command syntax.
SetIrrigationPracticeTSFromStateCU
Command Editor (see also the full-size image)
Command Syntax
The command syntax is as follows:
SetIrrigationPracticeTSFromStateCU(Parameter="Value",...)
Command Parameters
Parameter | Description | Default |
---|---|---|
InputFile required |
Path to the StateMod file to read. | None – must be specified. |
Examples
See the automated tests.
Troubleshooting
See the main troubleshooting documentation
See Also
FillIrrigationPracticeTSAcreageUsingWellRights
commandFillIrrigationPracticeTSInterpolate
commandFillIrrigationPracticeTSRepeat
commandSetIrrigationPracticeTS
commandSetIrrigationPracticeTSFromList
commandSetIrrigationPracticeTSPumpingMaxUsingWellRights
commandSetIrrigationPracticeTSSprinklerAcreageFromList
commandSetIrrigationPracticeTSTotalAcreageToCropPatternTSTotalAcreage
command